Engineering Mechanics

Proceedings Vol. 23 (2017)

ENGINEERING MECHANICS 2017

Copyright © 2017 Brno University of Technology, Faculty of Mechanical Engineering, Institute of Solid Mechanics, Mechatronics and Biomechanics, Brno

 

Nowakowski L., Skrzyniarz M., Miko E.
pages 734 - 737, full text

This article is to present the assessment of the impact of the installation of cutting plates in the body of the cutter on the vibration amplitude generated during machining and the 3D parameters of the geometrical structure of the surface. The research was conducted, respectively, for one, two, three, and six cutting plates mounted in the body of the endmill head CoroMill 245. The experiment was conducted at a vertical machining center AVIA VMC 800. The machined material was C45 steel. The measurements of displacements in the layout tool-workpiece were conducted with the use of a laser interferometer Renishaw XL-80, while the measurements of the geometrical structure of the surface were conducted with the use of an optical profilometer TalySurf CCI.

Text and facts may be copied and used freely, but credit should be given to these Proceedings.

All papers were reviewed by members of the scientific committee.