Engineering Mechanics

International Conference

Proceedings Vol. 23 (2017)


ENGINEERING MECHANICS 2017

23rd INTERNATIONAL CONFERENCE
May 15 – 18, 2017, Svratka, Czech Republic
;
Editors: Vladimír Fuis

Copyright © 2017 Brno University of Technology, Faculty of Mechanical Engineering, Institute of Solid Mechanics, Mechatronics and Biomechanics, Brno

ISBN 978-80-214-5497-2 (printed)
ISSN 1805-8248 (printed)
ISSN 1805-8256 (electronic)

list of papers scientific commitee

RETESTED RUNOUT SPECIMENS IN FATIGUE RESEARCH
Strzelecki P.
pages 938 - 941, full text

The problem of samples that did not break is quite often seen in fatigue tests. This situation particularly frequently occurs in the staircase method. With this in mind a question occurs whether these samples may be loaded again. This paper includes tests on steel S355J2+C for finite fatigue life, as well as for infinite fatigue life. The samples that did not break in the staircase method were repeatedly tested at higher load. The results obtained were compared with the results obtained on samples that had not been previously loaded. An impact of the previous tests was identified. With the use of statistic calculations, it is possible for adjust for the obtained values of cycle numbers, so that they correspond to the values of samples not previously loaded. The results obtained may be accepted as satisfactory.


back to list of papers

Text and facts may be copied and used freely, but credit should be given to these Proceedings.

All papers were reviewed by members of the scientific committee.


Publication Ethics - Ethical guidelines for publication
Webmaster contact: admin@it.cas.cz

imce   Powered by Imce 3.20  © 2023, Pavel Formánek, Institute of Thermomechanics AS CR, v.v.i. [generated: 0.0292s]