Engineering Mechanics

International Conference

Proceedings Vol. 22 (2016)


ENGINEERING MECHANICS 2016

22nd INTERNATIONAL CONFERENCE
May 9 – 12, 2016, Svratka, Czech Republic
;
Editors: Igor Zolotarev and Vojtěch Radolf

Copyright © 2016 Institute of Thermomechanics, Academy of Sciences of the Czech Republic, v.v.i., Prague

ISBN 978-80-87012-59-8 (printed)
ISSN 1805-8248 (printed)
ISSN 1805-8256 (electronic)

list of papers scientific commitee

THE ANALYSIS OF THE ZONE FOR INITIATING THE CUTTING PROCESS OF X37CrMoV51 STEEL
Nowakowski L., Miko E., Skrzyniarz M.
pages 457 - 460, full text

This article has presented the results of the research based on the analysis concerning the zone for initiating the process of longitudinal turning and face milling of X37CrMoV51 steel. The research was conducted in two stages at the laboratories of the Kielce University of Technology. The first stage included performance of cutting attempts that were to gradually initiate the process of cutting thanks to a flowing change of depth of the cutting by tilting the working surface of samples at a slight angle. The second stage was about performing measurements of the cuboidal and conical working surface of samples on a nonsliding contact profilometer TOPO 01P. As a result, the measurements acquired 2D profiles of the sample presenting the zone for initiating the cutting process. Profiles of the surface were analyzed in order to identify and compare the characteristic contact areas of the tool on the cut item. The results of the conducted analysis of 2D profiles of the working surface have been presented graphically.


back to list of papers

Text and facts may be copied and used freely, but credit should be given to these Proceedings.

All papers were reviewed by members of the scientific committee.


Publication Ethics - Ethical guidelines for publication
Webmaster contact: admin@it.cas.cz

imce   Powered by Imce 3.20  © 2023, Pavel Formánek, Institute of Thermomechanics AS CR, v.v.i. [generated: 0.0298s]