Proceedings Vol. 12 (2006)
ENGINEERING MECHANICS 2006
May 15 – 18, 2006, Svratka, Czech Republic
Copyright © 2006 Institute of Theoretical and Applied Mechanics, Academy of Sciences of the Czech Republic, Prague
ISSN 1805-8248 (printed)
ISSN 1805-8256 (electronic)
list of papers scientific commitee
pages 268 - +6p., full text
Various types of tooling clamping systems are used at design of machine tools. The typical representatives of clamping systems are CAPTO, ISO, UTS, HSK and other ones. Their design type execution, clamping principles and tool centring are different ones. Disadvantages can be seen most of all only during the machine operation. It can happen under usual operation conditions, but even more often under specific operation conditions, that e. g. the tool can be removed from the machine tool spindle only with big difficulties. This matter can be prevented by modification of operation conditions, by modification of applied design type execution at machine spindles, by adaptation of the tool part being clamped, etc. Whether the proposed modifications and adaptations are useful and which contribution they bring, this can be best evaluated on the basis of the problem analysis, using the technical calculations and tests. Properties and behaviors of the mechanical system, i. e. of the tool clamping device can be manifested by calculation modelling. This contribution describes numerical analysis of the ISO tool shank in the machine tool spindle without load and under operation load.
back to list of papers
Text and facts may be copied and used freely, but credit should be given to these Proceedings.
All papers were reviewed by members of the scientific committee.